Invertor Features :-
  • DSP based, less components, small size less electricity bill more efficiency
  • •Soft start features; protects appliances at startup.
  • Supply the highest quality pure sine wave power; protects your expensive household appliance and sensitive office equipments.
  • Over load and Battery. low protection.
  • AC Input low and high voltage cut off protections in both, inverter and U.P.S. modes.
  • •Silent operation of fans, tube light or appliances.
  • Quick change over from Mains to inverter mode. Special charging algorithm to enhance battery life.
  • Fully protected against short circuit of AC mains with output.
  • Intelligent charging; adapts itself to low, high battery, more and less power cut areas, battery health conditions.
  • High efficiency; better than 85%
  • Can be used as a normal inverter until solar panel connection Can operate on both solar and grid power
  • UPS always gives preference to solar power LED / LCD digital display
  • No load auto shutdown.
PV Module Features :
  • High efficiency 156mm poly crystalline cells
  • High quality Eva & back sheet to ensure high performance and provide good weather \ resistance for rugged environments.
  • Anodized aluminum alloy frame and tempered & textured clear glass with low iron content to enhance high efficiency.
  • Bypass diodes provided to avoid effect of partial shading.
  • IEC61215 Ed.2 & IEC61730 part1 and part2 certified
  • An iso 9001:2008 & iso14001:2004 certified production facility.
  • PV module power rating from 3wp, 25wp, 50wp, 100wp, 125wp, 250wp.
  • 25years limited warranty on power output. Output will be still 80% in 25 years, based on rated module performance less the negative tolerance.
Technical Specifications





Input voltage (UPS - Normal range)


N Input voltage (INV - Wide range)


Output voltage on mains mode

Same as input

Output voltage on inverter mode

220 ±5%

Output frequency on inverter mode

50Hz ±0.1Hz

Output waveform on mains mode.

Same as input

Output waveform on inverter mode.

Pure sine wave

Battery charging current

Constant charging approx 10% of the rated battery Current in AH.


Power factor controlled boost technology


> 80%

Inverter overload

120% for 10 sec

Inverter short circuit

Electronic shutdown


DSP based design.

Auto reset features


Module Rated Power Pmax - [W]

2000(250 X8no)

Nominal DC input voltage

24 VDC

Module Rated Voltage Vmax - [V]


Module Rated Current Imax - [A]


Module Open Circuit Voltage Voc - [V]


Module Short Circuit Current Isc - [A]


Module Tolerance


Standard Test Conditions

Irradiance 1000 W/ m2,Module temperature 25 °C, Spectrum AM 1.5